Crawl Space Repair Case Studies: Crawlspace Encapsulation in Marshall, NC

Wednesday, June 28th, 2017 by Braden Cook

Challenge

This home presented our crew with several problems. It was a pretty simple crawlspace job, mainly just needing to install our CleanSpace liner and a dehumidifier. The first issue that we ran into was the mold. It was not as overwhelming as some homes that we have been into, but there was a lot of it in the crawlspace. While mold is never a fun issue to deal with, it is definitely something we can take care of relatively easily

However, the real issue in this crawlspace was the clearance, which was going to be a huge hindrance to our team. Now, we are under no impression that crawl spaces are spacious areas to picnic under, but this crawlspace was hardly tall enough to belly crawl in. Luckily, most of our guys are used to these confined spaces, as claustrophobia is basically a part of the job description.

Solution

The solution was similar to every other CleanSpace job that we do here at All-Dry, with just a little less room. Having such a small area was definitely an inconvenience to the crew, but nothing that they were not able to overcome. It caused them to take a little more time in rolling out and securing the liner, but it was not much more than that.

The crew first started by laying out the drain matting for any water to drain out. After the drain mat was installed, our crew made their way through the crawlspace laying out the CleanSpace Liner. Belly crawling and pushing the liner out in front of them they finally got to the back walls, where there could secure the liner. The crew finished the job by installing the SantaFe Edge II dehumidifier. This dehumidifier does a great job on keeping the humidity level of the crawlspace in check.

Project Summary

Installing Contractor: All-Dry of the Carolinas

Systems Design Specialist: Paul Haenlein

Project Foreman: Francisco Gamez

Products Installed: CleanSpace Liner, SantaFe Edge II Dehumidifier, and Drain Matting

This picture gives a pretty good look at the clearance in the crawlspace. As you can see, it isn't much!

This photo shows just some of the mold that was present in the crawlspace. This mold was on the wood between two floor joists.

Here is the finished product! This gives another good angle of the crawlspace clearance. The CleanSpace is still laid out just as professionally as it would be in any other crawlspace.

Here is another view of the CleanSpace Liner. This side seems to have an even lower clearance than the pictures before.

This is the dehumidifier that this homeowner had installed in their crawlspace. It is a SantaFe Edge II dehumidifier, which helps to keep the humidity level at a reasonable level, a level low enough so that mold will not grow.

Back to Previous Page Back to Case Studies

Crawl Space Repair Case Studies: Crawlspace Encapsulation in Marshall, NC

Challenge

Solution

Project Summary

We serve the following areas