Simple Crawlspace Encapsulation in Chapin, SC

One of the most common projects that we do here at All-Dry of the Carolinas are full crawlspace encapsulations with CleanSpace. This basically means that at the very least, CleanSpace is laid over the entire crawlspace and is sealed to the walls. However, the CleanSpace is usually installed with several other products. Of course, the products that are used differ from job to job, depending on the severity of the problems, and what exactly the homeowner hopes to get from the system.

The "before" picture shows off the crawlspace before the CleanSpace was installed by the crew. However, the crawlspace didn't look quite this nice when the crew arrived. This photo was taken after they had cleaned out the area a little bit and sealed the vents, which can be seen along the top of the wall. Our Specialist noted a higher than average relative humidity level, which was one of the main concerns of the homeowner.

The "after" photo shows the same area, but with the CleanSpace almost completely installed. The liner has been completely laid out, with drainage matting under it, there is just one step left in the process, which you can actually see being done in this photo. One of the most important parts of installing CleanSpace is to make sure that it is sealed correctly. The reason that this is so important is because if the CleanSpace is not sealed correctly, then water vapor and moisture can still get into the area, which is exactly what we want to not happen.